Set wlan1 mode=ap-bridge wireless-protocol=802.11 band=2ghz-b/g/n frequency=auto ssid="**Your WiFi SSID**" enabled=yes Then, apply the following config: /interface bridgeĪdd name=lan auto-mac=no admin-mac= mac-address] If that's not the case just edit the script to fit the specifications of your router.įirst of all, do a System > Reset configuration (check No default configuration). I'll assume you are using a RB951 series router, which has ether1-5 and wlan1. If I connect the ethernet to the ether1-gateway port, I can successfully route through it (access the router etc) but then I'm not actually connecting the network together (which kind of defeats the point).Īny pointers as to where I'm going wrong would be gratefully received, this isn't something I normally do so stupid errors are not unlikely. Do I want to setup a DHCP relay? Setup a separate DHCP server? This is still the case after setting the DHCP client to attach to the bridge-local interface.
0 Comments
Leave a Reply. |